The wireless module is developed by Labs EM357, which is integrated with PA radio frequency chip in the ultra small size, which is in accordance with the IEEE802.15.4 specification and ZigBeePRO protocol. Module UART, I2C, SPI, JTAG debug interface, GPIO general digital input and output, AD analog input, etc., in order to quickly and lower into the customer's products, to save a lot of time, manpower and material resources, so as to shorten the product's market cycle. The product has been widely used in industrial automation, intelligent energy systems, security monitoring, building control, smart home, environmental protection, traffic light control and other fields.
Module factory burn independently developed by silicon serial transmitting firmware and the emberznet Pro standard protocol stack based on can replace wired serial communication in most situations, customers do not have to care about wireless technology implementation details, existing based on wired serial communication equipment replaced radio, no to the program to make any changes, the use of simple and convenient.
Module setup instructions
Module factory burn independently developed by silicon serial transmitting firmware, protocol after repeated application of large-scale projects repeated optimization can used in most of the wireless communication applications. If your application needs to be modified, we will have a professional engineer to provide you with software customization service.
Software running status is divided into Mode Running (Setting) and running state (Mode).
Running status: in the running state of the module in the serial transmission mode, all the data received by the serial port will be sent to the receiving end; all the data will be sent to the serial port by the serial port (relay node and special feature node exception).
Set the status: under the setting mode, can be set through the serial port on the module, channel address, baud rate and other parameters.
Conditions to enter the set state: module is power on or reset, if it is detected that the CFG pin for low level or through the serial port for receiving three or more spaces (38400 baud characters), then enter the set state.